Pig Traps That Catch the Whole Mob: A Practical Guide to Feral Pig Control in Australia
You have seen the damage before breakfast. A strip of sorghum flattened and rooted over, a trough fouled with mud, and the tracks of a mob that fed on your place all night and cleared out before sun-up. Shooting knocks over a few, and the rest learn fast. This guide covers how pig traps work, why so many trapping programs fall over, and how a modular trap with an automatic bait hopper lets one person run feral pig control without a daily trip to the site.
The Real Cost of a Feral Pig Mob
ABARES puts the cost of feral pigs to Australian producers at $156 million a year, split between $110 million in control spending and $46 million in lost production. The National Feral Pig Action Plan estimates a population of up to 24 million pigs across 45 per cent of the country, with the heaviest numbers in Queensland, the Northern Territory and New South Wales. A mob can grow by more than 85 per cent in a good season, which is why the plan says landholders have to remove 55 to 70 per cent of a local population every year to stop it growing.

On your own place the cost shows up in three spots. In the crop, pigs dig up planted grain and flatten standing sorghum and wheat. In the lambing paddock, pigs take lambs. A trial at Nyngan in central west NSW, published in 1981, recorded close to 38 fewer lambs per 100 ewes in a paddock with pigs than in a paddock without them in one autumn drop, and 32 fewer that spring. At the water, pigs wallow in dams and troughs, foul the supply, and carry diseases that can pass to cattle, working dogs and people.
Why Traditional Feral Pig Trapping Fails
Plenty of producers have tried pig traps, caught half a mob once and never seen the rest again. The trap is usually the reason.
Permanent welded traps end up in the wrong paddock
Pigs move with feed and water. The mob that hammered your oats in July is on the creek by December. A welded trap sits where you built it, and a silo trap of continuous mesh takes days to pull down and shift, so it spends most of the year at the wrong site.
Rusted welds and buckled mesh
A feral pig trap only has to fail once. When a 90 kilogram boar hits the mesh at full tilt, the first thing to go is a weld that rusted under cracked paint. Once a pig has pushed through a weak panel, that pig and every pig that watched it will give traps a wide berth.
Human scent at the bait site
The fatal mistake is the daily re-bait trip. Every visit leaves boot scent, diesel, a slammed door and the smell of the dog in the back of the ute. The national standard operating procedure for trapping feral pigs (NATSOP-PIG001) tells you to park well away, keep dogs off the site and stop shooting in the area. Older sows and any pig that has escaped a trap before are the most wary, and the standard allows one to two weeks of free feeding before the whole group feeds inside the trap. Walk in every day and you reset that clock.
The Advantages of a Modular Pig Trap
A modular pig trap is a set of mesh panels that bolt together with brackets in the paddock. Sunset Ridge Feeders builds its 2400mm Modular Pig Trap from panels 2410 millimetres long and 1520 millimetres high, which clears the 1.5 metre minimum the national standard sets to stop pigs jumping out. Two people can stand up a standard square trap in 20 to 30 minutes with no welding.
Scale the trap to the size of the mob
Mobs are unpredictable. A camera might show six pigs one week and 25 the next when two sounders join up on a water point. With a modular design you start with a standard four-panel square, which holds 20 or more pigs, and add panels when a bigger mob turns up. You can take panels off again for a small group or a tight site, and run the trap along a fence line to funnel pigs to the entrance. It sits on uneven ground, and star posts pin it down where the pigs push hard. A welded pressure rail along each panel stops the mesh buckling when a trapped pig charges, and the one-way repetitive entry gate keeps letting pigs in after the first one is caught, so the rest of the mob follows the leader inside.

Flat-pack pig trap: cut freight by up to 50 per cent
Freight is where rigid traps hurt. A pre-welded trap ships as a cage full of air, and the carrier charges for the space. Sunset Ridge panels leave the workshop in Parkes, NSW, flat-packed and stacked, which cuts freight by up to 50 per cent against a rigid pre-welded trap of the same size. Sunset Ridge quotes freight to your nearest depot or straight to the property, and an order of two or more traps brings the price or the freight down again.

Smart Pig Trapping Strategy: Free Feeding and Automation
The pig trapping tips below follow the national standard, and they work because they keep you away from the site.
How to trap feral pigs: the free-feed routine
Pick a site where pigs already feed: a water point, a wallow, a gap in the fence or the edge of the crop damage, with shade and vehicle access. Put out 5 to 10 kilograms of grain and lay a short trail if you need to draw the mob in. Pigs follow their nose, so soak wheat or barley for three to five days with a splash of molasses to lift the smell. Lay the panels on the ground near the feed for two or three days so the mob gets used to the smell of steel, then stand the trap up with the gate wired open and feed both inside and outside the pen. Once the grain inside is disappearing, feed inside only, and keep going until a trail camera shows every pig in the group feeding in the trap. Then set the gate in the evening, check it first thing in the morning, and keep setting each evening until the catches stop.

The wild pig bait hopper that does the daily run for you
The weak point in that routine is the daily feed. The Sunset Ridge Free Feeding and Bait Hopper holds about 250 kilograms of grain and bolts across the top rail of two trap panels. A built-in time clock drops feed into the pen at the times you program over a 24 hour cycle, so the mob learns that grain lands in the trap at dusk every day whether you are there or not. You fill it from outside the trap through a sliding lid, check the level through a side slot, and the gate stays fully open so pigs wander in and out without being spooked. At 10 to 15 kilograms a day, one fill runs two to three weeks, which covers the free-feed period for most mobs. Your only trips are to swap the camera card and, when the footage shows the full mob inside, to set the gate. The hopper also runs fermented grain, cracked corn or 1080 grain where your Local Land Services or Biosecurity Queensland permit allows it, with a baulk gate on the trap to keep cattle out.

Durability in the Aussie Climate
Pig traps live outside for months at a time. They sit in black soil mud through winter, bake in the high forties in January and get charged by pigs that weigh as much as a man. Painted traps rust at the welds within a few seasons, and thin imported steel goes faster. Every Sunset Ridge trap is 100 per cent Australian designed and manufactured. Logan and Harvey White build every panel and hopper in Parkes, in the central west of NSW, from heavy galvanised steel. Fully galvanised construction means there is no paint to crack and no bare weld for rust to get into, so the trap keeps its strength season after season.
Set Up a Trap That Matches Your Mob
If pigs are costing you crop, lambs or water, start with one standard 2400mm Modular Pig Trap and a Free Feeding and Bait Hopper, and add panels as the camera shows you what you are dealing with. Have a look at the Sunset Ridge 2400mm Modular Pig Trap and the Automatic Free Feeding and Bait Hopper, or call Logan on 0437 273 952 or Harvey on 0407 765 666 for a freight quote straight to your property. If you are ordering for a group of neighbours or a whole station, ask about pricing on multiple traps.

Comments